简介：AD / DA经典书籍
这是AD公司的两本经典教材，一本是ADC，一本是运放
Practical Analog Design Techniques
SECTION 1
SINGLE-SUPPLY AMPLIFIERS
Rail-to-Rail Input Stages
Rail-to-Rail Output Stages
Single-Supply Instrumentation Amplifiers
SECTION 2
HIGH SPEED OP AMPS
Driving Capacitive Loads
Cable Driving
Single-Supply Considerations
Application Circuits
SECTION 3
HIGH RESOLUTION SIGNAL CONDITIONING ADCs
Sigma-Delta ADCs
High Resolution, Low Frequency Measurement ADCs
SECTION 4
HIGH SPEED SAMPLING ADCs
ADC Dynamic Considerations
Selecting the Drive Amplifier Based on
ADC Dynamic Performance
Driving Flash Converters
Driving the AD9050 Single-Supply ADC
Driving ADCs with Switched Capacitor Inputs
Gain Setting and Level Shifting
External Reference Voltage Generation
ADC Input Protection and Clamping
Applications for Clamping Amplifiers
Noise Considerations in High Speed Sampling ADC Applications
SECTION 5
UNDERSAMPLING APPLICATIONS
Fundamentals of Undersampling
Increasing ADC SFDR and ENOB using External SHAs
Use of Dither Signals to Increase ADC Dynamic Range
Effect of ADC Linearity and Resolution on SFDR and
Noise in Digital Spectral Analysis Applications
Future Trends in Undersampling ADCs
SECTION 6
MULTICHANNEL APPLICATIONS
Data Acquisition System Considerations
Multiplexing
Filtering Considerations for Data Acquisition Systems
SHA and ADC Settling Time Requirements in Multiplexed Applications
Complete Data Acquisition Systems on a Chip
Multiplexing into Sigma-Delta ADCs
Simultaneous Sampling Systems
Data Distribution Systems using Multiple DACs
SECTION 7
OVERVOLTAGE EFFECTS ON ANALOG INTEGRATED CIRCUITS
Amplifier Input Stage Overvoltage
Amplifier Output Voltage Phase Reversal
Understanding and Protecting Integrated
Circuits from Electrostatic Discharge (ESD)
SECTION 8
DISTORTION MEASUREMENTS
High Speed Op Amp Distortion
High Frequency Two-Tone Generation
Using Spectrum Analyzers in High Frequency
Low Distortion Measurements
Measuring ADC Distortion using FFTs
FFT Testing
Troubleshooting the FFT Output
Analyzing the FFT Output
SECTION 9
HARDWARE DESIGN TECHNIQUES
Prototyping Analog Circuits
Evaluation Boards
Noise Reduction and Filtering for
Switching Power Supplies
Low Dropout References and Regulators
EMI/RFI Considerations
Sensors and Cable Shielding
简介：ADC和DAC基础:ADC和DAC基础第一部分，ADC和DAC基础第二部分，ADC和DAC基础第三部分，ADC和DAC基础第四部分,ADC和DAC基础第五部分。本系列文章分为5个部分，第一部分介绍采样的概念以及奈奎斯特（Nyquist）采样准则。第5部分同样也说明了如何运用欠采样和抗混叠滤波器。By Walt Kester and James Bryant, Analog Devices作者：Walt Kester 和James Bryant，美国模拟器件公司图2-1所示为典型的采样数据DSP系统的方框图。在实际模拟到数字的转换之前，模拟信号一般要经过某些种类的信号调节电路，这些信号要执行像放大、衰减和滤波这样的功能。需要用低通/带通滤波器把不需要的信号从有用带宽中消除掉，并能防止混叠发生。
京公网安备 11010802033920号
Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved
，
您当前积分：
评论